Wf15ss assembly instructions 90” gardenfall.
Inspection for shipping damage—any damage from shipping should immediately be reported to napoleon customer service or the store that it was purchased from. Do not attempt to operate if the unit is damaged. Parts list light/bracket with transformer(1) bag of river rocks (1) pump/filter valve assembl...
(figureb) 4. Place the glass distribution panel into the base until it has been inserted completely. (see figure b) 5. Holding a level against the glass to level, tighten the (4) wing bolts to secure the glass panel assembly. (figure c). (shim behind the glass frame as required to level) (figure c).
6. Assemble the valve / filter with the pump housing and tighten until they are positioned as illustrated in (figure d) (figure d) 7. Line up the pump filter / valve assembly to the hose coming out of the panel as shown in (figure e) screw the two connections together as shown in (figure f). Adjust ...
8. Pull the cable cord and light cord through the hole, see (figure h) (figure h) 9. Connect the transformer as shown, see (figure i) (figure i) 10. Fill the reservoir with water. Do not fill past the plug hole. Note: too much water flow will cause dripping and splashing. 11. Plug light and pump cor...
12. Adjust the valve handle to establish the preferred rate of water flowing down the waterfall. By moving the handle towards alignment with the pipe water flow will increase. Moving the handle so that it crosses the pipe will close off the valve and slow the water flow. 13. Place the (2) rock trays...
