Summary of NPL-U023
Page 2: Table of Contents
17 table of contents important precautions---------------------------------------------------------------------------------1 saftety hints and hardware packing list------------- -------------------------------------2 check list-------------------------------------------------------------------------...
Page 3: Safety Hints
18 safety hints 1. The high level of safety can be maintained only if it is examined regularly for damage and abrasion, please pay special attention to components most susceptible to wear, e.G. Rear stabilizer cap, transportation wheels, pedals, foam grip and seat. 2. Damaged parts need to be replac...
Page 4: Check List
Check list part description qty part description qty main frame /bolt/washer seat post/ slid post 48/2/12 1set 60/17 1set rear stabilizer /cap nut 1set 16/19/ 18/57 seat /bolt/ washer/knob 53/14 1set front stabilizer/pedal front post /tension knob 1set 33/35 27/26 1set water jug/handlebar cover moni...
Page 5: Assembly Instruction
Assembly instruction general remove all the part of your cycle from the carton and place them on the floor carefully. Assembling your cycle is simple. Follow these instructions carefully and it should take you around 15-20 minutes. Step1. Attach the front and rear stabilizer attach the rear stabil...
Page 6
Step2. Attach the seat and seat post attach the seat (16) to top seat bracket of seat slide tube（17) andtighten with washers (18) and nylon locknuts (19) securely. After that, then attach the seat slide tube (17) to seat post (60) and tighten with washer Φ32×Φ10.5×2（21）and turn the seat knob (22) ...
Page 7
Step3. Attach the front post remove the pre-assembled 4 allen head bolt (29), 4 curve washers (13) and 4 spring washers (12) from mainframe (48) . connect the socket of middle section sensor wire (30) to plug of middle section sensor wire (44). connect the lead head of middle section tension cab...
Page 8
Step4. Attach the handlebar and water jug ■ attach the handlebar (7) to front post (27) with two carriage bolt m8*75mm(9) two curve washer m8(12) two spring washer m8(13) and two cap nut(14) , clamp d ecoration cover (15) . 23.
Page 9
■ attach the water jug(23) to front post (27) with two flat pan head screw m5×15 (24) and one jug holder(25) . Step 6. Attach the computer 1. Connect the plug of middle section sensor wire (30) to the socket of top section sensor wire which come from monitor. 2. Connect the two sockets of hand pulse...
Page 10
Step 7. Attach the pedal and pedal strap 1. Identify the left pedal(35), which is marked with an "l".Using an 13×15 spanner, firmly tighten the left pedal counterclockwise into the left arm of the crank(37). Tighten the right pedal(35) clockwise into the right arm of the crank(37). Important: tighte...
Page 11
26.