For technical support, call 1-800-888-2710, m-f 9am-6pm est made in italy nb-t5000e, v.1 – june 2004 bike nashbar, 6103 rt. 446, canfield,oh 44406 www.Nashbar.Com.
• read and follow all instructions. • before beginning each workout, be sure bicycle is securely attached to trainer. • do not touch resistance unit during or immediately after use as it may become very hot. • keep children and pets away from trainer during use. • before you start any exercise progr...
Table of contents i. About your nashbar watt master trainer . . . . . . . . . . . . . . . . . . . . . . . .2 ii. Parts list . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 iii. Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ....
Viii. Changing the batteries the computer console uses 2 “aa” batteries. When the low battery life indicator appears in the display, or if the display is erratic, faint or disappears altogether, new batteries are needed. 1. To replace the batteries, remove the battery cover from the underside of the...
When battery life is low, a battery icon will flash in the display screen to indicate only a few hours of battery life remain. See figure 13. When the battery icon appears, replace the batteries as soon as possible (see section viii, “changing the batteries”). C. Reset at the beginning of each ride ...
Ii. Parts list part part code quantity trainer base..........................................................A ........................................1 mag resistance unit ............................................B ........................................1 knob bolt ................................
Erly positioned in the axle support cups, and that the right side axle support cup is securely tightened. 12. Tighten the knob bolt (c) until the drive roller contacts the rear tire. Then, turn the knob bolt an additional 3 complete rotations. If the tire slips on the roller, turn the knob bolt by a...
1. Press either button (set or mode) or begin pedaling to activate the computer. Current speed and other data should immediately appear in the display screen. 2. Adjust the resistance level (simulated slope) using the shift lever. Rotating the shift lever from the lowest setting (1) to the highest s...
