Natec Genesis HX88 User Manual - D. Hardware Installation
NATEC GENEsis HX88
11
2. Touch panel inline controller
d. HARdwARE INSTALLATION
1. Connect the Genesis HX88 Headset to the UsB port of the computer;
2. install the driver from the CD included in the package or download it from the
site
www.genesis-zone.com
;
3. Restart your computer.
NOTE
: to ensure that the headset is working properly, certain settings should
be configured as below:
1. select GENEsis HX88 in Control Panel
→
Audio
→
sound Playback;
2. select GENEsis HX88 in Control Panel
→
Audio
→
sound Recording;
E. USING THE HEAdSET
I. Using the touch controller
1. Touch power icon for 2 seconds to turn on. Touch for 2 seconds again to turn
off;
2. Tap power icon to change speaker channel volume adjustment mode from
main to FRONT, CTR, BACK, sUB, and siDE;
3. To change the volume, slide along the curve line above the genesis logo –
right to increase the volume level, and left to decrease;
4. To reset factory setting, touch the power icon for 5 seconds;
5. To mute the speakers, touch mute speakers icon. Touch again to unmute;
microphone mute
power and channel volume
control switch
speakers mute
volume control