National Cycle N936 Owner's Manual

INSTALLATION AND OWNER’S MANUAL

N936 LIGHTBAR for  

KAWASAKI 

®

NOMAD Motorcycle

PARTS LIST

Hex Key, 5mm

Wrench, 10mm

Screwdriver, #2 Phillips

Pliers

     Description                              

 Qty. 

Lightbar Assembly, N936  

1

Wire Connectors

6

Spacer

2

Screws, Hex, M6 x 35

2

Make certain the motorcycle is securely posi-

tioned for this installation.  Cover the front fender

with a protective cloth to avoid scratches.

1. Remove the headlight ring assembly from the

headlight shell (screwdriver), retain the screws for

re-use.  Set the headlight ring assembly safely aside.

2. Disconnect the turnsignals wires, inside the head-

light shell.

3. Remove the turnsignal mounting bar (hex key, 5mm

and wrench, 10mm), retain the end screws for re-use

PREPARATION

INSTALLATION

A. Mount the Lightbar

1. Position the National Cycle Lightbar assembly in the

same location as the original turnsignal mounting bar.

2. Thread the original end screws, through the Lightbar

mount holes, into their original locations.

3. Position the Spacers between the Lightbar center

bracket and the turnsignal mounting bar center mount-

ing location.

4. Thread the M6 x 35 Hex Head screws through the

Lightbar center bracket, the spacer, then into the lower

triple-clamp.

5. Tighten the end screws to 15 ft/lbs (14Nm).

6. Tighten the center screws to 6 ft/lbs (6Nm).

7. Route the Lightbar wires into the headlight shell.

B. Wire the Lightbar.

1. Attach the wires according to the following list: (Wire

Connectors and Pliers)

Turnsignal, Left

= RED

Turnsignal, Right

= RED

Running Lights

= BLACK

Passing Lamps

= BLUE

2. Grounding occurs through the frame.

3. Reinstall headlight.                        

Page 1 of 2

10-110736  Rev.B  07/02

Note: an assistant may be helpful 

during the installation.

Wire from 

Light Bar

insert to stop. 

Through Wire

M6 x 35

Screw 

Original

Screw 

Spacer