1. DL manuals
  2. National Instruments
  3. Cables and connectors
  4. CB-50
  5. Installation Manual

National Instruments CB-50 Installation Manual

Summary of CB-50

  • Page 1

    ____________________________ product and company names are trademarks or trade names of their respective companies. 320104-01 © copyright 1993, 1994 national instruments corporation. All rights reserved. October 1993 national instruments ® the software is the instrument ® installation guide cb-50 co...

  • Page 2: What Your Kit Should Contain

    2 what your kit should contain the cb-50 i/o connector block kit is available in three versions, depending on your requirements: • cb-50 with 0.5 m cable assembly • cb-50 with 1 m cable assembly • cb-50 without cable assembly in addition, each version of the kit contains the following components: • ...

  • Page 3

    3 component side of board align arrows align keying tab figure 1. Connecting the 50-pin connector to your data acquisition board 2. Firmly push in the connector for proper contact. 3. Insert the ejector ears into the connector block as shown in figure 2. Connector 2 4 6 8 10 12 14 16 18 20 22 24 26 ...

  • Page 4

    4 4. If you plan to mount your connector block for stability, choose one of the following procedures for mounting. If you do not want to mount your connector blocks, proceed to step 5. • for flush mounting, insert the flush-mount brackets into the connector block base as shown in figure 3. Flush-mou...

  • Page 5

    5 rail-mount bracket figure 5. Inserting the rail-mount bracket replace the end of the connector block and push very firmly until it snaps into place. Repeat for the other side, making sure that both rail-mount brackets are facing the same direction. Slide the rail-mount brackets of the connector bl...

  • Page 6: Removal

    6 6. Firmly push in the connector until the ejector ears on the block header connector snap into position. The numbers on the connector block correspond to the pin numbers of the rear panel i/o connector on the board. Removal 1. Press down on the ejector ears of the connector block. The connector wi...