National Instruments FIELDPOINT cFP-DO-403 Operating Instructions Manual

FIELDPOINT

™

 OPERATING INSTRUCTIONS

AND SPECIFICATIONS

FP-DO-403 and cFP-DO-403

16-Channel, 5 to 30 V Sinking Digital Output Module

These operating instructions describe how to install and use the 

National Instruments FP-DO-403 and cFP-DO-403 digital output 

modules, referred to inclusively as the [c]FP-DO-403. For 

information about configuring and accessing the [c]FP-DO-403 

over a network, refer to the user manual for the FieldPoint network 

module you are using.

Features

The [c]FP-DO-403 is a FieldPoint digital output module with the 

following features:

•

16 sinking digital output channels

•

Outputs that sink 2 A per channel, 16 A

2

 per module

•

Compatible with voltages from 5 to 30 VDC

•

250 V

rms

CAT II continuous channel-to-ground isolation, 

verified by 2,300 V

rms

, 5 s dielectric withstand test

•

–40 to 70 °C operation

•

ON/OFF LED indicators

•

Hot swappable

Installing the FP-DO-403

The FP-DO-403 mounts on a FieldPoint terminal base (FP-TB-

x

), 

which provides operating power to the module. Installing the 

FP-DO-403 onto a powered terminal base does not disrupt the 

operation of the bank.

To install the FP-DO-403, refer to Figure 1 and complete the 

following steps:

1. Slide the terminal base key to either position X, used for any 

module, or position 6, used for the FP-DO-403 module.