1. DL manuals
  2. National Instruments
  3. Switch
  4. GPIB-BUF
  5. User Manual

National Instruments GPIB-BUF User Manual

Manual is about: National Instruments Switch User Manual

Summary of GPIB-BUF

  • Page 1

    © copyright 1989, 1994 national instruments corporation. All rights reserved. Gpib-buf user manual february 1994 edition part number 320125-01.

  • Page 2

    National instruments corporate headquarters 6504 bridge point parkway austin, tx 78730-5039 (512) 794-0100 technical support fax: (800) 328-2203 (512) 794-5678 branch offices: australia (03) 879 9422, austria (0662) 435986, belgium 02/757.00.20, canada (ontario) (519) 622-9310, canada (québec) (514)...

  • Page 3

    Microgpib products national instruments has developed the microgpib product line to offer a series of high performance, low cost ieee 488 support items that are packaged in small all-metal cases, capable of being rack mounted. Limited warranty the gpib-buf is warranted against defects in materials a...

  • Page 4

    Action accrues. National instruments shall not be liable for any delay in performance due to causes beyond its reasonable control. The warranty provided herein does not cover damages, defects, malfunctions, or service failures caused by owner’s failure to follow the national instruments installation...

  • Page 5

    Fcc/doc radio frequency interference compliance this equipment generates and uses radio frequency energy and, if not installed and used in strict accordance with the instructions in this manual, may cause interference to radio and television reception. This equipment has been tested and found to com...

  • Page 6

    There is no guarantee that interference will not occur in a particular installation. However, the chances of interference are much less if the equipment is installed and used according to this instruction manual. If the equipment does cause interference to radio or television reception, which can be...

  • Page 7: Contents

    © national instruments corp. Vii gpib-buf user manual contents about this manual .......................................................................... Ix introduction to the gpib-buf ................................................... Ix organization of this manual ................................

  • Page 8

    Contents gpib-buf user manual viii © national instruments corp. Appendix a hardware specifications .............................................................. A-1 appendix b customer communication .......................................................... B-1 glossary ...............................

  • Page 9: About This Manual

    © national instruments corp. Ix gpib-buf user manual about this manual introduction to the gpib-buf the gpib-buf is one of national instruments family of microgpib products. These products are high-performance, low-cost ieee 488 support items, packaged in small all-metal cases, capable of being rack...

  • Page 10

    About this manual gpib-buf user manual x © national instruments corp. Conventions used in this manual the following conventions are used in this manual. Italic italic text denotes emphasis, a cross reference, or an introduction to a key concept. Bold italic bold italic text denotes a note, caution, ...

  • Page 11: Chapter 1

    © national instruments corp. 1-1 gpib-buf user manual chapter 1 description of the gpib-buf this chapter contains general information about the national instruments gpib-buf and lists components and accessories. Introduction the gpib-buf, shown in figure 1-1, is an ieee 488 (gpib) data buffer which ...

  • Page 12

    Description of the gpib-buf chapter 1 gpib-buf user manual 1-2 © national instruments corp. The gpib-buf has two isolated gpib ports and is placed in-line between a gpib system and a single, slower gpib device (usually a printer or plotter). The gpib-buf automatically buffers all device-dependent da...

  • Page 13

    Chapter 1 description of the gpib-buf © national instruments, corp. 1-3 gpib-buf user manual the gpib-buf front panel the power switch and six light emitting diodes (leds) are mounted on the gpib-buf front panel. Figure 1-2 shows the front panel of the gpib -buf. Gpib-buf ieee-488 ieee-488 buffer po...

  • Page 14

    Description of the gpib-buf chapter 1 gpib-buf user manual 1-4 © national instruments corp. The gpib-buf rear panel figure 1-3 shows the power cable and the gpib cables connected to the rear panel of the gpib-buf. Figure 1-3. The gpib-buf rear panel the gpib connectors the gpib-buf has two gpib conn...

  • Page 15

    Chapter 1 description of the gpib-buf © national instruments, corp. 1-5 gpib-buf user manual the port labeled gpib in is intended to be connected to a gpib system that includes one or more gpib devices which send data to the gpib target device. All data received via the gpib in port is transferred i...

  • Page 16: Chapter 2

    © national instruments corp. 2-1 gpib-buf user manual chapter 2 installation and operation this chapter describes the procedures for installing and operating the gpib -buf. Figure 2-1 shows an example of a gpib-buf connected to a gpib system. This example shows a gpib-buf placed in a gpib system wit...

  • Page 17

    Installation and operation chapter 2 gpib-buf user manual 2-2 © national instruments corp. Installation install the gpib-buf according to the following procedure. 1. Inspect the gpib-buf. 2. Verify the voltage requirement. 3. Configure th e operating parameters. 4. Connect the cables. 5. Power on th...

  • Page 18

    Chapter 2 installation and operation © national instruments corp. 2-3 gpib-buf user manual step 3. Configure the operating parameters the gpib-buf is shipped from the factory configured to operate at a gpib primary address of 5 with the srq-on-empty function disabled and device clear recognition and...

  • Page 19

    Installation and operation chapter 2 gpib-buf user manual 2-4 © national instruments corp. Set configuration switches use the dip switch at location u38 on the printed circuit board to configure the gpib primary address and operating modes of the gpib-buf. The dip switch has eight configuration swit...

  • Page 20

    Chapter 2 installation and operation © national instruments corp. 2-5 gpib-buf user manual table 2-2. Configuration parameters for switches 4 through 8 switches 4 5 6 7 8 indication off off off off off sets gpib primary address 0 off off off off on sets gpib primary address 1 off off off on off sets...

  • Page 21

    Installation and operation chapter 2 gpib-buf user manual 2-6 © national instruments corp. Table 2-2. Configuration parameters for switches 4 through 8 (continued) switches 4 5 6 7 8 indication on off on off off sets gpib primary address 20 on off on off on sets gpib primary address 21 on off on on ...

  • Page 22

    Chapter 2 installation and operation © national instruments corp. 2-7 gpib-buf user manual step 5. Power on the unit power on your target device then power on your gpib-buf by using the front panel rocker switch. The power led should light immediately and the ready indicator should blink while the u...

  • Page 23: Chapter 3

    © national instruments corp. 3-1 gpib-buf user manual chapter 3 technical information this chapter contains a more detailed description of the operation of the gpib-buf. The timing characteristics of the parallel port are provided in this chapter. The gpib-buf is actually a powerful 8-bit microcompu...

  • Page 24

    Technical information chapte r 3 gpib-buf user manual 3-2 © national instruments corp. If the srq-on-empty feature is enabled, the gpib-buf asserts the service request (srq*) signal on the gpib in port. The srqcondition can be used to signal the gpib controller that the gpib-buf is powered on and re...

  • Page 25

    Chapter 3 technical information © national instruments corp. 3-3 gpib-buf user manual dma controller transfers the data directly to the internal data buffer without processor intervention. Thus, gpib transfer rates as high as 900 kbytes/s are possible. The gpib-buf turns off the empty indicator as s...

  • Page 26

    Technical information chapte r 3 gpib-buf user manual 3-4 © national instruments corp. When receiving data while addressed as a gpib listener, the gpib-buf buffers the state of the eoi* signal line along with the data byte it corresponds to using an additional on-board ram module. Therefore, the gpi...

  • Page 27

    Chapter 3 technical information © national instruments corp. 3-5 gpib-buf user manual polling the gpib-buf the gpib-buf can return status information to the gpib controller through the serial poll response byte as shown in figure 3-1. This byte contains two bits of information that reflect the curre...

  • Page 28

    Technical information chapte r 3 gpib-buf user manual 3-6 © national instruments corp. The gpib-buf srq-on-empty feature and serial poll status byte are useful for several reasons. • a remote controller is able to tell when a data transfer to a plotter or printer is completely finished. • a ready in...

  • Page 29

    Chapter 3 technical information © national instruments corp. 3-7 gpib-buf user manual internally, the local individual status (ist) bit of the gpib-buf is reset to 0 when the internal data buffer is empty of data. It is set to 1 when the internal data buffer is not empty. Therefore, after the gpib c...

  • Page 30

    Technical information chapte r 3 gpib-buf user manual 3-8 © national instruments corp. Special note about timeouts if your current gpib system relies on a timeout method to ensure a non- functioning gpib device does not hang the bus indefinitely, then it may be necessary to adjust or disable the tim...

  • Page 31

    Chapter 3 technical information © national instruments corp. 3-9 gpib-buf user manual internal data buffer. This mode can be used to prematurely abort a lengthy plot or print. Neither group execute trigger (get), go to local (gtl), nor local lockout (llo) have any effect on the gpib-buf. The gpib in...

  • Page 32: Appendix A

    Chapter 1 description of the gpib-232cv © national instruments corp. 1-1 gpib-232cv user manual appendix a hardware specifications this appendix lists the electrical, environmental, and physical specifications of the gpib-buf. Table a-1. Electrical characteristics characteristic specification power ...

  • Page 33

    Hardware specifications appendix a gpib-buf user manual a-2 © national instruments corp. Table a-3. Physical characteristics characteristic specification case size 1.6 in. By 5.7 in. By 8.4 in. (40.6 mm by 144.8 mm by 213.4 mm) case material all metal enclosure rack mounting single or dual kits avai...

  • Page 34: Appendix B

    © national instruments corp. B-1 gpib-buf user manual appendix b customer communication for your convenience, this appendix contains forms to help you gather the information necessary to help us solve technical problems you might have as well as a form you can use to comment on the product documenta...

  • Page 35: Technical Support Form

    Technical support form technical support is available at any time by fax. Include the information from your configuration form. Use additional pages if necessary. Name company address fax ( ) phone ( ) computer brand model processor operating system speed mhz ram mb display adapter mouse yes no othe...

  • Page 36

    The problem is list any error messages the following steps will reproduce the problem.

  • Page 37: Hardware Configuration Form

    Hardware configuration form record the settings and revisions of your hardware on the line to the right of each item. Update this form each time you revise your hardware configuration, and use this form as a reference for your current configuration. National instruments products • gpib-buf revision ...

  • Page 38: Documentation Comment Form

    Documentation comment form national instruments encourages you to comment on the documentation supplied with our products. This information helps us provide quality products to meet your needs. Title: gpib-buf user manual edition date: february 1994 part number: 320125-01 please comment on the compl...

  • Page 39

    If you find errors in the manual, please record the page numbers and describe the errors. Thank you for your help. Name title company address phone ( ) mail to: technical publications national instruments corporation 6504 bridge point parkway, ms 53-02 austin, tx 78730-5039 fax to: techn ical public...

  • Page 40: Glossary

    © national instruments corp. G-1 gpib-buf user manual glossary prefix meaning value µ - micro 10 -6 m- milli- 10 -3 k- kilo- 10 3 m- mega- 10 6 ° degrees % percent a amperes ac alternating current ansi american national standards institute c celsius emi electromagnetic interference fcc federal comm ...