National Instruments NI PXIe-1085 User Manual - page 4
4
|
ni.com
|
NI PXIe-1085 Modular Power Supply User Guide
Figure 2.
Removing Modular Power Supply from Power Supply
Installation
Ensure that there is no visible damage to the new power supply assembly. Verify that the housing
and connector on the new power supply assembly have no foreign material inside. Install the
new power supply assembly into the opening in the power supply in the reverse order of
removal. Replace and tighten the four screws with a Phillips screwdriver.
After installing the power supply assembly, slide the power supply into the opening in the rear
of the chassis. Tighten the eight screws with a Phillips screwdriver.
Configuration
The fan-speed selector switch is on the rear panel of the power supply. Select
High
for maximum
cooling performance (recommended) or
Auto
for quieter operation. Set the Inhibit Mode switch
to the
Default
position.
1
Power Supply
2
Modular Power Supply
3
Modular Power Supply Handle
3
2
1