National Instruments PXIe- 1065 Manual - page 7
7/9
www.ni.com
External 10 MHz Reference Out (BNC on rear panel of chassis)
Accuracy
±25 ppm max. (guaranteed over the operating temperature range)
Maximum jitter
5 ps RMS phase- jitter (10 Hz– 1 MHz range)
Output amplitude
1 V
±20% square- wave into 50 Ω 2 V
unloaded
PP
PP
Output impedance
50 Ω ±5 Ω
External Clock Source
Frequency
10 MHz ±100 PPM
Input amplitude
Rear panel BNC
200 mV
to 5 V
square- wave or sine-wave
PP
PP
System timing slot PXI_CLK10_IN
5 V or 3.3 V TTL signal
Rear panel BNC input impedance
50 Ω ±5 Ω
Maximum jitter introduced by backplane
1 ps RMS phase- jitter (10 Hz– 1 MHz range)
PXIe_SYNC_CTRL
V
IH
2.0 –5.5 V
V
IL
0– 0.8 V
PXI Star Trigger
Maximum slot-to- slot skew
250 ps
Backplane characteristic impedance
65 Ω ±10%
Note For PXI slot to PXI Star mapping, refer to the
section of the
. For other specifications, refer to the
System Timing Slot
NI PXIe- 1065 User Manual
PXI-1 Hardware
.
Specification
PXI Differential Star Triggers (PXIe- DSTARA, PXIe- DSTARB, PXIe- DSTARC)
Maximum slot-to- slot skew
150 ps
Maximum differential skew
25 ps
Backplane differential impedance
100 Ω ±10%
Note For PXIe slot to PXI_DSTAR mapping, refer to the
section of the
. For other specifications, the NI PXIe- 1065
System Timing Slot
NI PXIe- 1065 User Manual
complies with the
.
PXI-5 PXI Express Hardware Specification
Mechanical
Overall dimensions
Standard chassis
Height
6.97 in. (177.1 mm)
Width
18.30 in. (464.8 mm)
Depth
18.40 in. (467.4 mm)
Note 0.57 in. (14.5 mm) is added to height when feet are installed. When tilted with front feet extended on table top, height is increased approximately 2.08 in. (52.8 mm)
in front and 0.583 in. (14.8 mm) in rear.
Weight
12.8 kg (28.2 lb)
Chassis materials
Sheet Aluminum (5052- H32, 3003- H14, and 6061- T6), Extruded Aluminum
(6060- T6), and Cold Rolled Steel, PC-ABS, Santoprene, Nylon
Finish
Conductive Clear Iridite on Aluminum, Electroplated Nickel on Cold Rolled
Steel Polyurethane Enamel
The following two figures show the NI PXIe- 1065 chassis dimensions. The holes shown are for the installation of the optional rack mount kits. You can install those kits on the
front or rear of the chassis, depending on which end of the chassis you want to face toward the front of the instrument cabinet. Notice that the front and rear chassis mounting
holes (size M4) are symmetrical.
NI PXIe- 1065 Chassis Dimensions (Front and Side)