Powered rs-232 2-port pci card user manual ver. 1.00 all brand names and trademarks are properties of their respective owners..
Mn2000000198 page 2 contents: chapter 1: introduction ...................................................... 3 1.1 product introduction .................................................... 3 1.2 features ........................................................................ 4 1.3 system requiremen...
Mn2000000198 page 3 chapter 1: introduction 1.1 product introduction rs-232 i/o series, a line of universal pci multi-port serial communication board, is designed for both 3.3v/5v 32/64-bit pci bus with plug and play feature. It can be installed in virtually any available pc system and compatible wi...
Mn2000000198 page 4 1.2 features compliant with pci 3.0 specification support 2 x uart serial ports built-in 16c950 compatible uart 128-bype deep transmit/receive fifos data transfer rate up to 230400bps optional rs-232 signal or power output to serial device provides 5vdc or 12vdc power output via ...
Mn2000000198 page 5 1 x driver cd 1 x user manual 1 x fan out cable note: contents may vary depending on country/market. Chapter 2: getting started 2.1 hardware installation 1. Turn off the power to your computer. 2. Unplug the power cord and remove your computer’s cover. 3. Remove the slot bracket ...
Mn2000000198 page 6 cd-rom type power supply connector to provide the higher currents required by the power peripherals. In order to get efficient intake current output, there is one set of 4-pin power connector designed on the board. The 4-pin power set draws both +12vdc and +5vdc power output for ...
Mn2000000198 page 7 caution 1. Be sure to confirm your serial device power voltage sourcing and pin number to prevent any further problem. 2. Before plugging this board into your system, please carefully check the power output jumper setting and hardware installation steps to prevent any damages. 3....
Mn2000000198 page 8 com 1 port – 4 th pin normal(dtr) 5v 12v com 1 port – 8 th pin normal(cts) 5v 12v com 1 port – 9 th pin normal(ri) 5v 12v com 2 port – 1 st pin normal(dcd) 5v 12v.
Mn2000000198 page 9 com 2 port – 4 th pin normal(dtr) 5v 12v com 2 port – 8 th pin normal(cts) 5v 12v com 2 port – 9 th pin normal(ri) 5v 12v note: 1. System default setting is normal mode, standard rs-232 pin.
Mn2000000198 page 10 define. 2. No described pins mean standard rs-232 definition. 2.3 driver installation 2.3.1 installation for windows xp/vista/7 1. Insert the provided cd into your disk drive. The cd-rom will start automatically. The following screen will show up and please click “install driver...
Mn2000000198 page 11 3. Follow the instructions on screen to install the driver. 2.3.2 installation for linux 2.4.X/2.6.X please refer to the installation guide and driver for linux 2.4.X & 2.6.X operation system installation within the folder located in the cd driver. :\driver\pci\linux 2.3.3 insta...
