National Instruments TPC-2206 User Manual - Compliance

Compliance

Electromagnetic Compatibility Information

This hardware has been tested and found to comply with the applicable regulatory requirements and limits for electromagnetic 

compatibility (EMC) as indicated in the hardware’s Declaration of Conformity (DoC)

1

. These requirements and limits are 

designed to provide reasonable protection against harmful interference when the hardware is operated in the intended 

electromagnetic environment. In special cases, for example when either highly sensitive or noisy hardware is being used in close 

proximity, additional mitigation measures may have to be employed to minimize the potential for electromagnetic interference.

While this hardware is compliant with the applicable regulatory EMC requirements, there is no guarantee that interference will 

not occur in a particular installation. To minimize the potential for the hardware to cause interference to radio and television 

reception or to experience unacceptable performance degradation, install and use this hardware in strict accordance with the 

instructions in the hardware documentation and the DoC

1

.

If this hardware does cause interference with licensed radio communications services or other nearby electronics, which can be 

determined by turning the hardware off and on, you are encouraged to try to correct the interference by one or more of the 

following measures:

•

Reorient the antenna of the receiver (the device suffering interference).

•

Relocate the transmitter (the device generating interference) with respect to the receiver.

•

Plug the transmitter into a different outlet so that the transmitter and the receiver are on different branch circuits.

Some hardware may require the use of a metal, shielded enclosure (windowless version) to meet the EMC requirements for 

special EMC environments such as, for marine use or in heavy industrial areas. Refer to the hardware’s user documentation and 

the DoC

1

 for product installation requirements.

When the hardware is connected to a test object or to test leads, the system may become more sensitive to disturbances or may 

cause interference in the local electromagnetic environment.

Operation of this hardware in a residential area is likely to cause harmful interference. Users are required to correct the 

interference at their own expense or cease operation of the hardware.

Changes or modifications not expressly approved by National Instruments could void the user’s right to operate the hardware 

under the local regulatory rules.

1   

The Declaration of Conformity (DoC) contains important EMC compliance information and instructions for the user or 

installer. To obtain the DoC for this product, visit 

ni.com/certification

, search by model number or product line, 

and click the appropriate link in the Certification column.