National Security Systems Security System User Manual - page 18
READY TO ARM
(custom text)
SYSTEM COMMAND
ALL SECURE
EXIT NOW
Arm Your Entire System with
Delays
I have this feature.
I do not have this feature.
COMMAND 1 is used to arm the entire system, both perimeter and interior
zones. Once you have entered COMMAND 1, the exit delay time starts.
You now have a predetermined amount of time to exit the protected area
before the system arms. During the exit period you may move through
motion detectors or any protected area on your way to the exit door without
causing an alarm. To cancel COMMAND 1, enter your personal passcode
and press
ENT
.
NOTE
:
If you leave the building
after
the exit time expires, you may begin
the entry delay, or initiate an alarm. If this happens, disarm your system by
entering your personal passcode and press
ENT
. If your
system reports to a Central Station, you may need to call them if an alarm
occurs.
Application
COMMAND 1 is useful in applications where you want your cleaning
service, a serviceman or anyone to arm your system when they leave, but
you don't want them to have the code to disarm the system. COMMAND
1 arms the system, but it will
not
disarm the system.
ALL SECURE
(custom text)
COMMAND
1
Using COMMAND 1:
Display:
1. Ensure that all zones are secure.
2. Press the
COMMAND
bar.
3. Press the
1
key.
The
ARMED
indicator light begins to flash on and off. This indicates
that the system has begun exit delay time.
4. The indicator will remain lit when the
delay time has expired and the
system becomes armed.
5. To disarm your security system, enter your personal passcode and
press
ENT
before the delay time expires.