1 http://www.National.Com national semiconductor june 2009 rev 0.9 evaluation board user’s guide adc10dv200, 10-bit, 200 msps a/d converter adc11dv200, 11-bit, 200 msps a/d converter © 2009 national semiconductor corporation..
2 http://www.National.Com table of contents 1.0 introduction ......................................................................................................................................... 3 2.0 board assembly ...................................................................................
3 http://www.National.Com 1.0 introduction this evaluation board may be used to evaluate the adc10dv200, or adc11dv200. The adc is one of a family of 10 and 11 bit converters that provides data at rates of up to 200mhz. Further reference in this manual to the adc10dv200 is meant to also include the ...
4 http://www.National.Com figure 2. Test set up 3.0 quick start refer to figure 1 for locations of jumpers, test points and major components. Refer to figure 2 for the test set up. The board is configured by default to use a external clock source and internal reference. Refer to section 4.0 and the ...
5 http://www.National.Com input signals can also be amplified using an onboard lmh6517 dvga (u601). To use the dvga, some components must be installed and some removed. The following components must be installed: r651-r656. The following components must be removed: r302, r303, r309, and r310. Then c...
6 http://www.National.Com 6.0 hardware schematic.
7 http://www.National.Com.
8 http://www.National.Com.
9 http://www.National.Com.
10 http://www.National.Com.
11 http://www.National.Com.
12 http://www.National.Com 7.0 evaluation board layout layer 1 : component side layer 2 : ground.
13 http://www.National.Com layer 3 : ground layer 4 : power.
14 http://www.National.Com layer 5 : ground layer 6 : circuit side.
15 http://www.National.Com 8.0 evaluation board bill of materials item qty reference part part number vendor ______________________________________________ 1 15 c201,c220, .1uf pcc1762ct digi-key c301,c302,c313,c314, c315,c316,c504,c509,c514, c518,c547,c549,c551 3 8 c305,c309,c311, .1uf 490-1318-1 d...
16 http://www.National.Com 46 3 r401,r404,r405 10k 311-10karct digi-key 47 2 r402,r403 5.1k 311-5.1karct digi-key 70 6 tp501,tp502,tp503,tp504, gnd 5002k digi-key tp505,tp506 71 1 tp507 va 5002k digi-key 72 1 tp508 vd 5002k digi-key 73 1 tp509 vclk 5002k digi-key 74 1 tp510 vdr 5002k digi-key 100 4 ...
17 http://www.National.Com appendix a1.0 operating in the computer mode the adc10dv200 evaluation board is compatible with the wavevision5™ data capture board and wavevision5™ software. You can download the latest version from: http://www.National.Com/analog/adc/wavevision5 when connected to the wav...
18 http://www.National.Com a2.4 clock circuit solder jumper settings components can be installed or removed to select the path of the clock to the adc.While not as convenient as pin-type jumpers, these introduce less distortion into the clock signal. Termination a: differential sinusoid install c210...
19 http://www.National.Com by using this product, you are agreeing to be bound by the terms and conditions of national semiconductor's end user license agreement. Do not use this product until you have read and agreed to the terms and conditions of that agreement. If you do not agree with them, cont...
Important notice texas instruments incorporated and its subsidiaries (ti) reserve the right to make corrections, modifications, enhancements, improvements, and other changes to its products and services at any time and to discontinue any product or service without notice. Customers should obtain the...
Mouser electronics authorized distributor click to view pricing, inventory, delivery & lifecycle information: texas instruments : adc10dv200eb/nopb.
