Nature Sauna NTSB-20 User handbook manual - Insulation.
Nature Sauna Inc. Canada. 3625 Loreto Rue, Brossard, QC, Canada. TEL: (1)514-663-2291 Website: www. naturesauna.com
6
3. Do not bake food in heater.
4. Keep away from the heater when it is hot, you may get hurt by the outer surface of the heater.
Insulation.
The door, ceiling and walls of sauna room must be insulated. 10.76 ft
2
(1m
2
) of un-insulated surface increases the
cubic volume approximated 40.37 ft
3
(1.2m
3
) when determine the power requirement of the heater
Make sure that moisture proof is appropriate in sauna room. Purpose of this is to prevent spreading of moisture to
the other rooms or wall structure. Moisture proof must be placed between panel and heating insulation. Moisture and
thermal proofing should be installed from outside to inside:
1.
Recommend that the MIN thickness of the thermal insulation in the walls is 2” and in the ceiling 4”.
2.
Aluminum foil laminate can be affixed over the heating insulation as a vapor barrier.
3.
Leave at least 0.8” air slot between vapor barrier and inside panel.
4.
Leave a slot between wall panel and ceiling to prevent gathering moisture behind the panel.
Spruce wood is recommended as material of wall and ceiling.
Heating
Ensure there is nothing near the heater before switching on it. The heater and the stones may emit smells when you
use the heater for the first time. Make sure that the sauna room has been efficiently ventilated or open the sauna room
door. It will take about an hour to reach suitable temperature in sauna room if the output of heater is proper.
(CHART 6) ;
The temperature that user preferred to is about 140-194℉. Too powerful heater will heat sauna room too quickly
and the temperature of stones may remain insufficient. Consequently, water thrown on the stones will run through and do
not produce sufficient vapor. On the other hand, if the heater is underpowered the heating time will be much longer.
Malfunctions
If the heater doesn’t work, check the following (Note: switch off the heater before maintenance >.
1. front frame 2. stove side frame 3. heating element 4. terminal block
5. heating element holder with o-rings 6. cable holder 7. name plate 8. supply wire set.
Warning: Never put cover on the heater; Do not use heater without stone;
Do not put wood on the heater; Do not use chlorinated water.
CHART 7: DIMENSION OF SAUNA HEATER
10.04"
11.02"
22.
44
"
14.
17
"
4.1
3"
16.14"
14.17"
NTSB-45~NTSB-90
18.
9"
15.
75
"
8.07"
7.09"
12.01"
NTSB-20,NTSB-30