Natures Flame Camino Manual - 13. Television
Page 8
13. Television
Clearances
If electrical equipment (eg Plasma TV, LCD TV or home
theatre) is to be installed above the wood pellet fi re, we
recommend installing a mantle below the TV screen, or
recessing the TV screen into the wall, for heat protection.
The clearances shown are recommended minimums,
and are to be treated as suggestions only.
The end user is responsible for checking the installation
instructions and clearance requirements of their electrical
appliances to ensure the appliance is suitably located
in relation to the wood pellet fi re. Nature’s Flame and
Ecoteck does not guarantee that these recommended
clearances will be appropriate for all electrical equipment
50mm (min)
40mm
330mm
Mantle
Television
50mm (min)
40mm
330mm
14. Flueing
Each 55 Built-in-Heater Flue Kit
(non-Chimney installation) contains:-
This flue kit may be used in new or existing timber
chimneys. The overall height of the flue is 3.6m.
Kit is supplied in a carton.
Note: The Davin 55 Built-in-Heater Flue Kit
(non-Chimney) complies with AS/NZS
2918:2001 as per Applied Research Test
Report 05/1185, dated 15 September 2005.
All fires must be installed by a qualified
installer as per the manufacturer’s
instructions and AS/NZS2918:2001.
600mm from
roof
penetration
110mm minimum
clearance if lined
flue
150mm
(minimum)
Part No.
Description
Quantity
1
Galvanised outer liner
Ø100mm x 900mm long
4
2
Stainless steel inner liner
Ø75mm x 900mm long
4
5
Inner/outer flue liner spacer
4
8
Rain cap 75mm
1
9
Rain cap 100mm
1
702
Support Angle 950mm Long
2
55
Ecoteck Sara & Camino - new home
(non-Chimney installation)
Each 54:1 Built-in-Heater Flue Kit
(Chimney installation) contains:-
This flue kit may be used in new or existing timber
chimneys. The overall height of the flue is 3.6m.
Kit is supplied in a carton.
Note: The Davin 54:1 Built-in-Heater Flue Kit
(Chimney) complies with AS/NZS
2918:2001 as per Applied Research Test
Report 05/1185, dated 15 September 2005.
All fires must be installed by a qualified
installer as per the manufacturer’s
instructions and AS/NZS2918:2001.
Part No.
Description
Quantity
1
Galvanised outer liner
Ø100mm x 900mm long
4
2
Stainless steel inner liner
Ø75mm x 900mm long
4
5
Inner/outer flue liner spacer
2
8
Rain cap 75mm
1
9
Rain cap 100mm
1
10
Telescopic offset 75mm (Stainless)
(2 x 45° bends)
2
11
Telescopic offset 100mm (Galvanised)
(2 x 45° bends)
2
702
Support Angle 950mm Long
2
54:1
Ecoteck Sara & Camino - new home
(Chimney installation)
Heat-resistant
floor protector
Seismic restraint
(to be fitted)
Chimney to
be flashed
by builder
150mm
(minimum)
Chimney cover
– optional extra
NOTE: Camino must be installed on an approved, raised-stand, while Sara can be installed lower to the fl oor with an
optional 45mm base.