Nauticam NA-GX1 Instruction Manual - page 11
10
1. After verifying that the housing O-ring is in good condition, lightly
coat it with the lubricant provided.
2. Make sure the O-ring groove located in the front part of the
housing is free from any foreign material; the groove can be
cleaned with the aid of a microfiber cloth.
3. Place the O-ring into the groove.
Setting up the moisture alarm
1. Install
the
CR2032
battery
provided
into
the
battery
compartment on the circuit board
inside the rear part of the housing.
2. Test the alarm by contacting the
two wires near the bottom of the
housing with a damped cotton bud;
the alarm should start giving out a
repeating “beep” sound along with
a flashing red light. The “beep”
sound and the light should keep on
going for 5 seconds after the
removal of the damped cotton bud.