Nav TV AUDI-P60 Manual - page 3
BHM
12/12/16
NTV-DOC277
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
3 |
P a g e
AUDI-P60 Installation
1. Remove the MMI module located in glove box – this will require an 8mm socket and
possibly a right-angle driver. Disconnect any associated
harnesses and set the MMI radio aside.
2. Grab the provided ‘Power/CAN Harness’ from the
AUDI-P60 kit. Connect the following wires to the car:
3. Locate the factory PINK (For AUDI’s with NAV, this connector is GRAY),4-pin round
connector that was removed from the radio
in step 1. Connect this factory plug to the
AUDI-P60 interface at the port labeled
‘VIDEO OUT’.*
4. Connect the smaller white plug
side of the provided LVDS
Video Cable to the port on
the AUDI-P60 interface
labeled ‘VIDEO-IN’.
5. Connect the free end of the provided LVDS Video Cable (green) back to the factory radio
at the appropriate port.
Interface wires
Connect to car
Location
Black (Ground)
Chassis Ground
PIN 15 (Radio plug)
Red (ACC 12v)
ACC 12v (+)
Black/White or Black/Blue
@ pass fuse box