Nav TV FLIR-XW NTV-KIT588 User Manual - page 3
BHM
05/28/15
NTV-DOC206
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
3 |
P a g e
FLIR-XW Operation
- Any time the FLIR II camera detects an animal or pedestrian (any time a yellow box is
detected), the following takes place:
LED will emit from the LED-button
Tone will sound from the warning speaker
OUTPUT 1 sends 12v (+) for as long as the object is detected/yellow box is
shown (this wire is tied to the LED normally)
- Press MUTE Button (1x) to immediately mute the warning sound for that object
detection circumstance.
The sound from the XW speaker will continue to stay muted for 10
consecutive seconds without an additional object detected. If an object is
detected within the 10 seconds, the XW will stay muted (for heavily
populated areas)
- Press and HOLD MUTE Button (~2 seconds) and the speaker will tone twice, and stay
muted until the next key cycle. This feature can be reset without a key cycle by pressing
and releasing the MUTE button again.
- The LED will illuminate when an object is detected by the FLIR II. If the warning (sound)
is muted, the LED will continue to illuminate until 10 consecutive seconds have passed
without an object detection. If the LED output wire was spliced to trigger an external
monitor (optional), the image will display as long as the LED is on.