Nav TV Ford 4 UNI-CAM NTV-KIT600 User Manual - page 3
BHM
05/01/15
NTV-DOC211
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for misuse of its product.
If you do not agree, please discontinue use immediately and return product to place of purchase. This product is intended for off-road use and passenger
entertainment only.
3 |
P a g e
Module Installation
1.
Remove the 4” media screen from the dashboard, above the CD player.
2.
Connect the provided
Plug & Play T-Harness
to the OEM ford 12-pin plug previously
connected to the radio.
3.
After installing and running your reverse camera to the dash opening, connect your RVC
signal to the
RED
RCA found on the
Plug & Play T-Harness
.
Power your camera
with an
ACC source if planning to use the force camera feature (OUTPUT 1, 1 amp MAX).
4.
Optional
: if connecting a secondary (front) camera or AUX video source, connect the
following:
a.
Connect the
front camera signal
to the
BLACK
RCA
from the 18-pin UNI-CAM
harness.
b.
Connect the
rear camera signal
to the
YELLOW
(female)
RCA from the 18-pin UNI-
CAM harness.
c.
Connect the
YELLOW
(male) RCA to the
BLACK
RCA (may already be complete)
from the screen side of the plug & play harness.
See diagram for visual aid
(page 5).
5.
Optional:
If adding a secondary (front) camera, connect
INPUT 2
(Blue) to 12v
through a toggle switch
for activation. Sending 12v (+) to INPUT 2 will force the connected front image at any time.
6.
Optional:
If the user desires to force the rear camera at any time, connect
INPUT 1
(Red) to 12v
through a toggle switch
for activation. Sending 12v (+) to INPUT 1 will force the connected rear image
at any time.
7.
Connect the UNI-CAM module to the 18-pin harness on the Plug & Play T-Harness.
8.
Connect the male end of the Plug & Play T-Harness to the screen and proceed to the next section.