Nav TV NTV-KIT217 User Manual - page 2
2 |
P a g e
Agreement:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for misuse of its product.
If you do not agree, please discontinue use immediately and return product to place of purchase.
Installation
1.
Disconnect the factory 40 pin plug from behind the radio and plug it into
the supplied aftermarket 40 pin adapter harness.
2.
Unplug the fiber optic cable from the factory 40 pin plug.
*
Assemble the
supplied fiber optic cable into the M.O.S.T. loop in the order pictured
below then reinsert the optic cable into the supplied 40 pin plug in the
same location as you removed it from on the factory connector (radio
side). Plug in the new fiber terminal into the supplied OPV-970 board.
3.
On the OPV-970 power harness, find a reliable continuous power and
ground connection. Connection at the T-harness is recommended (All
connections should be soldered and insulated). Red is power and Black
is ground.
4.
The supplied T-harness will have a pair of RCA’s plugged into each
other. Disconnect these two RCA’s
5.
Connect the “VIDEO OUT” cable of the OPV to the RCA going towards
the radio (female).
6.
Connect the “CAM IN” cable of the OPV to the RCA going towards the
car (male).
#
7.
Connect the external AV source to the OPV-970.
8.
Plug the VTC-970 into the 8 pin Molex connector of the T-harness.
9.
Insert the radio side of the supplied T-harness into the radio.
10. Test then reassemble.
*Follow the instructions to the right for proper assembly of the fiber optic lines.
# If installing the PCM3.1 CAM, the aftermarket camera plugs into the “CAM IN” cable of the
OPV.
12 Pin Molex wiring guide
12 Pin Molex connector image
Pin (1) Video out (high)
Pin (2) Video in (high)
Pin (4) Left audio (high)
Pin (3) Camera in (high)
Pin (5) Right audio (high)
Pin (6) Ground (Black wire)
Pin (7) Video out (low)
Pin (8) Video/CAM in (low)
Pin 10 Left/Right audio (low)
Pin (12) Constant +12volts In
Operation
Video in motion is automatic and doesn’t need any programming or
activation. Whenever an external video source is present, the radio will
always show an image.
To operate A/V input:
1.
Press the source button.
2.
Press the TV icon.
3.
Once in the TV screen, tap above the preset icons in any blank
area to display the
image.
08/20/14
NTV-DOC
116
rB2