Nng-toyota 2 navigation interface for select toyota vehicles ntv-kit607 ntv-doc229 3950 nw 120 th ave, coral springs, fl 33065 tel 561-955-9770 fax 561-955-9760
Installation guide remove a/c vent remove 4 screws from radio step 1 step 2 removed radio step 3 step 4 step 5 remove radio mount navigation for rav4 removed clip step 6 remove all screws to open up the lcd screen removed clip ntv-doc229 ntv-doc229.
Installation guide navigation for rav4 1. Place mask tape on radio to avoid drilling scrap 2. At bottom of the radio, center of the radio, drill a hole drill a hole to run video cable 1. Place the touch screen ribbon in factory lcd screen board 2. Place the factory touch screen ribbon into daugther ...
Installation guide navigation for rav4 place 3 spacers and 3 screwsn to the red circle position install video board place radio ribbon from radio side to video board socket run the video cable from inside video board to outside the radio ntv-doc229.
Installation guide navigation for rav4 overall wiring figure connect the following: tp in (yellow) lcd out (pink) rear lcd power connector gps antenna external speaker external switch 1. Place the 10pin (non-jbl ) or 20pin ( jbl) power harness 2. Place the module under the radio ntv-doc229.
Installation guide navigation for rav4 dip sw setting 1 on oem camera / no camera 1 off aftermarket camera 2-8 off if 28pin t-harness do not include in the package please connect reverse wire manually don't forget to connect reverse wire to activate oem camera activate oem camera/ after market camer...
Ntv-doc229.
Weak /no gps signal? Tips to improve gps antenna signal if vehicle equipped metallized windshield* “gps monitor tools” exit igo map by press shut down button console> setup gps monitor locate the antenna with minimum 5 bars in dark blue or gray bar (always suggest mounting the gps antenna on the roo...
Proper gps antenna position if vehicle equipped *metallized windshield suv/coupe sedan truck (shown as tundra) alternatively, installer might choose to mount antenna inside the headliner or inside vehicle using gps monitor tools (see instruction). However, stay away from the windshield. * windshield...
Igo primo map path setting 1. Press setup ‐> navigate setup 2. Press on the folder icon 3. Select the following path in storage card ‐> cyb_navi.Exe 4. Press home button on the top left corner and press navigation 5. System should able to run into “igo primo”.
