Nav TV NTV-KIT701 Instruction Manual - page 7
BHM
10/09/15
NTV-DOC243
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
7 |
P a g e
If adding a front camera OR Aux Video source:
1. Disconnect POWER/CAN Harness from interface
2. Place DIP SWITCH 1 in the DOWN position, reconnect power
3. Press the iNAV button on the steering wheel to activate ‘NAV input’
4. Press OK button on remote 4 times, then press POWER
SET – FRON CAM must be turned on if adding a front camera and the user
wishes for automatic front camera switching. Options for 5, 7, 9 or 11
seconds are user-selectable for the length of time the front camera input
stays active once the vehicle is placed out of reverse.
If the user wants only an AUX video input without front camera, set AV1-
SEL to ON
Once finished with settings, place DIP SWITCH 1 back into the UP position
and reset power to interface.
Menu Adjustments
Before you start:
1. The IR-Eye must be connected
2. Make sure the car’s ignition is on and radio is on
3. You must be in Reverse Camera mode
OR
AUX Video mode (see
below):
Reverse Camera Mode adjustsReverse Camera Settings
AUX Video Mode adjusts AUX Video Settings
4. Press the OK BUTTON 4 times (numbers will display per press),
then press POWER.
5. The OSD Menu will appear on screen (auto-time out in about 5
seconds if no action occurs).
Functional Parking Guidelines ON/OFF
Parking Distance Control
ON/OFF (while in reverse)
Adjust FPG Position
Adjust PDC Position
‘Safe to move?’ ON/OFF
PDC
Return
(AUX VID
menu
control)
RVC Menu
AUX
VIDEO
Menu