Nav TV NTX-54 Installation Manual - Quick Start User’S
12 |
P a g e
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for misuse of its product. If you do
not agree, please discontinue use immediately and return product to place of purchase. This product is intended for off-road use and passenger entertainment only.
NTX-54 Nissan/Infiniti Navigation System
wire:
Programming PINK ‘INPUT’ wire:
Setup:
IF YOU ARE NOT INSTALLING ANY AFTERMARKET CAMERAS OR VIDEO INPUT, SKIP THIS SECTION AND GO STRAIGHT TO THE
"OPERATION" SECTION.
Note:
-These programming sequences only need to be performed one time. To deprogram, just repeat the above step(s).
- If the factory image does not reappear, press anywhere on the touchscreen. When the screen returns the factory
image, the feature should be programmed.
When this wire is programmed, the screen will display ‘Aux
Video’ from the silver NTX54 module when the PINK ‘INPUT’
wire sees 12v (+), regardless of what source is currently
displayed. This must be programmed if adding a rear camera.
While in the factory screen mode, press and hold the top right
corner of the screen until the screen goes completely black (this
will take about 20 seconds). Release the top right corner and wait
until the factory image can be seen again.
Quick Start User’s
Guide
Programming PINK ‘INPUT’ wire for REV Cam: