Nav TV PCM4-CAM User Manual - page 5
BHM
06/16/16
NTV-DOC262
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
5 |
P a g e
7. Connect ground and power for your camera (use an ACC source for power) and run to
the front of the vehicle.
8. Connect the video feed from the camera to the RCA among the main power harness
labeled ‘CAMERA’.
9. Connect the white plug from the Power/CAN Harness to the port on the PCM4-CAM
interface labeled ‘POWER CAN’.
10. Optional:If adding an additional video input (including front camera), connect the video
signal to the RCA among the Power/CAN Harness labeled ‘FRONT’.
11. Start the car and test for proper functionality before replacing any dash pieces.
12. If the screen does not transition to reverse image when in reverse, connect the
Green
wire labeled ‘REVERSE’ to an OEM reverse lamp 12v (+) wire
. This is sometimes the
case with manual transmission-equipped vehicles.