Nav TV SVS-6 Install Manual - page 10
BHM
07/6/15
NTV-DOC209
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for misuse of its product.
If you do not agree, please discontinue use immediately and return product to place of purchase. This product is intended for off-road use and passenger
entertainment only.
10 |
P a g e
SVS-6 FAQs
Q1. I have the front camera connected to a toggle switch. Whenever I turn it off, the camera says on for a
period of time afterwards.
A1. Check dipswitch 4 is in the UP position. In the DOWN position, the front camera will stay on as long as the
input has 12v, but the timer doesn’t start until 12v is removed.
Q2. Can I change the priority of the video inputs, or which one will display over the other?
A2. No, the video input priority cannot be reconfigured.
Q3. When I connect my camera signals, the image will turn on and off with the blinkers.
A3. Verify you’re using the Turn Signal camera inputs.
Q4. When I put my vehicle into reverse, the backup image will display but none of the other images will
show. The radio will not transition and only shows the radio screen.
A4. The reverse wire that would normally connect to the radio has to be removed and connected to RVC
INPUT of the SVS-6. REV_OUT (pin 21) from the SVS-6 is then connected to the reverse wire of the radio. You
cannot connect both the vehicles reverse wire and SVS-6 OUTPUT wire together at the radio. By doing so, it
may power the reverse bulbs any time the cameras are requested & can potentially damage both the SVS-6
and/or the vehicle’s BCM.