Nav TV TOOKI-POR Manual

LOCATION & REMOVAL 

With the head unit now removed locate the power ISO 

plug and the Black optical plug shown below. 

Insert OPTICAL leads into TOOKI-POR loom and car loom 

to create loop, see diagram below 

To remove the (out) fibre optic cable from the factory con-

nector you will need to remove the black outer casing and 

push out the blue locking insert. You will need to do the 

same to insert the cable into the supplied loom. (shown in 

previous fig) 

Next plug in the power link loom into the car harness, plug 

in the microphone (supplied) and insert optical plug into 

the interface. 

INSTALLATION 

Firstly to determine if your PCM unit is compatible, 

press and hold the MAIN & TRIP buttons to display 

the PCM Software version. Should be 2.0 or above 

Installation is made at the front unit. 

To remove the head unit you will need to remove the 

surrounding trim then the 4 screws securing the unit, as 

below. Some models are removed with specific radio 

keys. 

TOOKI-POR is designed to work with a radio that has a 

factory SIM card based GSM phone option rather than 

Bluetooth. As such, certain functions displayed on the 

radio are not supported by the TOOKI-POR. 

The factory phone module (if fitted) will need 

to be removed from its power and optical con-

nection (optical cables must be re-connected 

to continue loop) This module is located under 

the drivers (O/S) seat on all models. It is possi-

ble to install the TOOKI kit at the Factory 

phone location and allocate 12v+ perm and 

ground. 

INTERFACE

CAR CONNECTOR

    OUT cable from screen 

IN cable from interface 

1. Press TEL on PCM Radio. 

2. “Tooki Searching” indicates no phone connected. 

3. Start the pairing procedure on your mobile phone. 

Make sure the Bluetooth feature is turned on. Con-

sult your phone’s manual for phone-specific pairing 

procedures. 

4. Once your mobile phone discovers Tooki xxxx (last 

4 digits will vary), select and pair Tooki. 

5. When prompted for a passkey, enter 6888 on your-

mobile phone. 

6. Once pairing is complete, press TEL and select  

“phonebook” Choose the phone you wish to pair, and 

select. After a short while you  should see your signal 

strength indicator and phone book list on the PCM Ra-

dio. Pressing “Tel” will then show you your network pro-

vider and signal strength.  

7. You may pair up to 5 different mobile phones. For 

information on phone selection, section 6 

8. To delete a paired phone select phone book, scroll to 

the phone name you wish to delete, select the name 

by pushing the rotary button. When the name is se-

lected scroll to “delete” on screen and you should 

see the message “are you sure you want to delete” 

select yes. 

9. you may use any of the units hard keys as well as 

the on screen lists to dial out.  

OPERATING INSTRUCTIONS