Nav TV TOYCAM NTV-KIT057 Install Manual - page 3
BHM
08/15/14
NTV-DOC188
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
3 |
P a g e
8. Reconnect all the harnesses to radio, reassemble the dash and test by starting the car
and placing it into reverse. The reverse image should activate automatically (whenever
in reverse).
9. Perform this step only if nothing happens on the factory display when the vehicle is
placed into reverse:
a. Locate the Gray, 5-PIN plug on the back side of the radio and find the factory
harness that connects to it (if no harness exists, skip to step d).
b. You’ll likely need to pry the pin-lock free on the back side of the factory
connector (look closely).
c. Insert the pin fully into the connector in the position shown below:
d. Supply a 12v + signal while in reverse only (tap at reverse light) to the free end
of the Rear-Trigger Pin. Verify operation by placing vehicle into reverse.