Nav TV UCI-11C NTV-KIT331 User Manual - page 4
4 |
P a g e
Programming UCI for 4.3" Monitor
Adjusting the rearview camera settings
PRIOR TO ADJUSTING ANY SETTING AFTER THE INITIAL INSTALLATION, TURN THE VEHICLE OFF,
CLOSE ALL DOORS, THE HOOD AND TRUNK AND LOCK THE VEHICLE WITH THE FACTORY KEY FOB
OR LOCK IT WITH THE KEY. WAIT ONE MINUTE AND THEN UNLOCK THE VEHICLE AND PROCEED
WITH THE FOLLOWING STEPS.
To access the settings screen, press and
hold the “Settings” button on the upper
right of the 4.3" monitor for 3 seconds.
On the touch screen, press “Camera Input
Settings” to select it...
Adjusting the input:
-
Touch the “Input” soft key
-
Every press of the icon will change
the input; OFF, DIFF (factory
camera), Video 1, Video 2, Video 3.
The input image will be displayed in
the back ground once the correct
input is selected.
- Once programming is complete, place the vehicle in reverse and your camera image should appear on the
monitor. Screen will show blue if a camera is not connected.