NavCom Technology SF-3040 Quick Start Manual - page 2
2 of 4
SF-3040 Quick Start Guide, Rev. B
13. Depending on the current Connection Type, do not
change the default option, COM Port, or select USB.
COM Port Settings
USB Settings
14. Set the appropriate options according to the Connection
Type:
• COM Port:
• COM Port: The appropriate PC COM Port
• Baud Rate: 57600 (keep the default)
• Parity: None (keep the default)
Or
• USB Port:
• COM Port: The appropriate virtual PC COM Port
15. Click
to ensure the baud rate is correct for the
selected port.
16. Click
.
17. Verify that the SF-3040 is connected to the PC:
Messages scrolling in the Communication window
indicate that the connection is established:
Determine Firmware Versions
The user determines that the firmware installed in the
SF-3040 is the most current. The version of the installed
firmware is important to the proper operation of the receiver.
18. On the Detailed Views menu, click Receiver Options to
open the Receiver Options tab.
19. Click
(refresh) on the Firmware Info window to
display the installed options.
20. Browse to the NavCom\Firmware folder on the PC. The
Firmware folder is copied from the SF-3040 Product
Configuration USB Flash Drive. It contains the most
current firmware. The firmware file extension is *.s19.
Open the Readme.txt file for additional
information.
21. Compare the current NAV Firmware version in the
Firmware folder with the installed version displayed in
the Firmware Info window.
In the example above, the NAV firmware in the
receiver matches the firmware in the folder.
22. Perform one of the steps below:
• If the NAV firmware installed in the receiver is the
most current version, go to the Upload Software
Options section.
• If the NAV firmware installed in the receiver is not the
most current version:
• Check the versions of the other firmware.
• Write down all the firmware that must be updated.
• Go to the Upload Firmware section below.
Firmware in Receiver
Current NAV Firmware
NAV Firmware
Click the
Refresh
button
Firmware Info Window
Click the
Refresh
button
NAV Unified
Firmware File