Gm720 gm725 quick installation guide v.1.0 1 quick installation guide gps mouse receiver model: gm720 gm725.
Gm720 gm725 quick installation guide v.1.0 2 quick installation guide gps mouse receiver model: gm720 gm725 before you start your new navibe gps mouse allows you to turn any pdas (pocket pc) or pcs into a gps navigation system. 1. Introduction…………………………………………………3 2. Hardware description…………………………………...
Gm720 gm725 quick installation guide v.1.0 3 introduction the navibe systems gps-mouse is a high performance gps receiver, designed with sirf star iii (gsc3f base band processor with intergrated flash memory and rf front end) single chipset. By using sirf star iii single chipset, gps-mouse processes...
Gm720 gm725 quick installation guide v.1.0 4 technical support if you have any questions or problems installing the gps mouse, please contact technical support. Hours: weekdays 9 a.M. ~ 6 p.M. Taiwan http://www.Navibe.Com e-mail: service@cpss.Com.Tw for gm725 please do not use ps2 converter to direc...
Gm720 gm725 quick installation guide v.1.0 5 hardware description performance receiver 20 parallel channels frequency l1, 1.57542 ghz, c/a code acquisition time cold approximately 42 seconds, typical ttff(95%) warm approximately 38 seconds, typical ttff(95%) hot approximately 01 seconds, typical ttf...
Gm720 gm725 quick installation guide v.1.0 6 interface gm725connector ps-2 connector gm720 connector usb 1.1 male connector baud rate 4.8k (default) to 57.6k bps adjustable i/o protocol nmea 0183 gm725 i/o connector 6-pin gm720 i/o connector 4-pin antenna build-in patch antenna physical characterist...
Gm720 gm725 quick installation guide v.1.0 7 gm725 pin assignment remark: 1. I/o: ps2 connecter 2. Cable length of 2 meters 3. Connecting with 6-pin rs232 bridge pin signal name 1 rx (ttl) 2 rx (rs-232) 3 ground 4 tx (rs-232) – gps output (nmea) 5 tx (ttl) – gps output (nmea) 6 +5 vdc.
Gm720 gm725 quick installation guide v.1.0 8 gm720 pin assignment remark: 1. I/o: usb 1.1 connector 2. Cable length of 2 meters pin signal name 1 +5 vdc 2 -data 3 +data 4 ground.
