NAVICOM RT-550 Owner's Manual - page 18
6.9 DSC
SETUP
The submenu is used to set behavior of the DSC/ATIS function.
The following 6 items are available for selection.
User MMSI
Group Setup
ATIS MMSI
ATIS ENABLE
DSC ENABLE
POS REPLY
6.9.1
ENTER YOUR USER MMSI (USER MMIS)
This is a once-only operation.
You must enter your user MMSI first then you can access the DSC
functions.
1
Select DSC SETUP then USER MMSI and press the CH knob. If an
existing MMSI is stored, the values appear.
2
If the MMSI is blank, a dashes line appear. Enter user MMSI along
the dashed line. Press the CH knob to confirm each correct entry to
move to the next digit.
If your make an error, press +/- key or rotate CH knob. < appears,
then press the CH knob to backup and correct the entry.
Hold the CH knob to store your user MMSI.
4
3
Enter your user MMSI again as a password check, hold the CH knob to
permanently store the your user MMSI and return to the menu.
5
You can view your stored user MMSI at anytime by selecting user MMSI
in the DSC SETUP menu.
6
If there is no USER MMSI stored and the radio's DSC function is
attempted, the radio says "PLEASE INPUT USER MMSI" as below.
DSC WARNING MESSAGE
31
32
6.9.2.2 EDIT USER GROUPS
1
2
Select DSC SET/UP then GROUP SETUP and press the CH knob. The
existing names & MMSI data are displayed on screen. Select the Group
name or, only the MMSI that you wanted
Press the CH knob to edit. The entry procedures are same as that of the
BUDDY LIST
3
when the edition is finish press the CH knob to store the changes and
return to the GROUP MMSI screen.
INPUT USER
MMSI
> - - - - - - - -
USER MMSI
INPUT AGAIN
> - - - - - - - -
PLEASE INPUT
USER MMSI
6.9.2.3 DELETE A GROUP
1
Select GROUP SETUP and press the CH knob. The existing group
names are displayed on screen
2
Select that you wanted delete and press the CH knob will display
EDIT or DELETE item
3
Select DELETE and press the CH knob will display DELETE
GROUP menu arrow point the YES, then press the CH knob to
empty the group and return to the GROUP SETUP screen. The LCD
displays the group as follow.
GROUP SETUP
MANUAL NEW
> EILEEN
FRIENDS
EDIT NAME
>EILEEN
EDIT MMSI
053421608
EILEEN
053421608
>EDIT
DELETE
6.9.2 MAINTAIN GROUPS
You can program up to three group MMSI numbers and associated Group
names, group MMSI numbers always begin with a zero (0). You only enter the
last 8digits of the group ID number, the intial "0" is automatically entered.
6.9.2.1 ENTER YOUR GROUPS
1
Select GROUP SETUP and the cursor is at
existing names & MMSI data are stored, the values appear.
2
If is blank, Only MANUAL NEW appear on LCD
The entry procedures are same as that of the BUDDY LIST.
DSC SETUP
USER MMSI
>GROUP SETUP
ATIS MMSI
GROUP SETUP
>MANUAL NEW
EILEEN
GROUP NAME
> - - - - - - - - - -
GROUP MMSI
O - - - - - - - -
USER MMSI
500000001
>STORE
CANCEL
Navicom RT-550
Navicom RT-550