Navigon 12 Series User Manual - 4.1 Information
User’s manual NAVIGON 12xx | 22xx
- 18 -
Operating the NAVIGON 12xx | 22xx
4
Operating the NAVIGON 12xx | 22xx
4.1 Information
Various information symbols are located at the top of many windows.
GPS
The GPS symbol can indicate the following GPS reception states:
No GPS (No symbol): The built-in GPS receiver is not operational.
Contact customer service if the problem persists.
No Signal: Data is being received from less than three satellites.
Position cannot be calculated.
GPS Ready: Data is being received from at least three satellites.
Position can be calculated.
For details of the GPS status refer to chapter "GPS Status, saving the
current location" on page 46.
Compass
The Compass symbol indicates in which direction you are currently
heading. It can indicate the following points of the compass:
N, NE, E, SE, S, SW, W, NW.
TMC (Traffic Information)
The NAVIGON 22xx has an integrated TMC receiver which provides
the navigation system with traffic information updates. If necessary it
can change your route dynamically, for example in order to avoid a
traffic jam.
Note: This function is only available if TMC traffic messages are being
transmitted in the country in which you are travelling. This is not the
case in all countries.
The TMC symbol can display the following TMC reception status:
Tuning: The TMC receiver is operational but cannot find a station that
is transmitting TMC signals. There are no active traffic messages.
Tuning: The TMC receiver is operational but cannot find a station that
is transmitting TMC signals. Traffic messages are active however. This
can be the case, for example, when travelling through a tunnel.