Navigon 42 easy User Manual - page 31
User’s manual NAVIGON 42 Easy | 42 Plus | 42 Premium
Navigation
- 31 -
A single signal tone and the symbol
(
Speak) indicate that the
navigation system is waiting for your voice command.
2. Follow the instructions given by the navigation system.
When you have finished entering the address, the map will open in
Route preview mode. The destination is indicated on the map.
Note: The Voice Command function is not available for every
language. In the languages for which this function is not available, the
Voice Command button does not appear.
7.2.4
Points of interest
Points of Interest, called POI for short, are useful addresses that are
catalogued according to particular criteria.
POIs include ports, airports, restaurants, hotels, petrol stations, public
buildings, doctor's surgeries, hospitals, shopping centres, etc.
Points of interest can be displayed on the map by means of a symbol.
In the
N
AVIGATION
window tap on
(More) > Navigation
Settings > Map Display > Categories Shown in order to select the
categories you want to appear on the map.
POI nearby
POIs nearby are POIs located within a certain radius of your current
location. This means you can always find the nearest petrol station for
example, no matter where you are.
Note: GPS reception must be good enough for determining your
position. Check the (GPS Ready) symbol to see whether GPS
reception is good enough.
If GPS reception is not good enough, the system will look for POIs near
the last known position. If there is no last known position, the
POI
Nearby function will not be available.
For more details refer to the chapter "Initialising the GPS receiver" on
page 26.
1. In the
N
AVIGATION
window tap on Enter Destination > Search for
POI > Nearby.
The
C
ATEGORY
window opens.
2. Select a category from which you would like to find a POI.
Categories in which no destinations are available nearby cannot be
selected.
If sub-categories exist for the category you have selected, the Sub
Category list opens.
3. Select the sub-category from which you would like to select a POI.