Navigon 70 plus live User Manual - page 61
User’s manual NAVIGON 70 Easy | 70 Plus Live
Working with the map
- 61 -
The Reality View mode shows with greater clarity the signposting and
lanes you must follow.
This display does not change until you have passed the spot indicated.
The map will then change back to Navigation mode.
►
If you want to change to Navigation mode before then, just tap on
any point on the map.
Note: The Reality View mode is not available for all motorway
junctions and three-leg motorway junctions. Availability depends on the
map material used.
7.6.2
Navigation in Pedestrian mode
This mode is active if you have selected a pedestrian route profile for
the navigation. These profiles can be identified by the
(Pedestrian)
symbol.
After the route was shown in Preview mode, navigation was started.
You receive a route proposal which is calculated on the basis of the
digitalised road system. You are also shown in which direction your
destination lies. If you leave the proposed route, for example in order to
take a more pleasant route through a park, you will still see at all times
the direction in which your destination lies.
Please note:
►
You will receive no navigation instructions. Instead you will receive
a message when you are getting close to the destination.
►
The map view follows your movements so that your position is
always visible on the screen.
►
If you leave the calculated route, the route will not be recalculated
automatically.
►
If you are navigating on a route and more route points are still to
follow, navigation to the next route point will be started immediately
after the message.
►
Traffic messages are not taken into account.
Note: In pedestrian mode you must take care to hold the device without
covering it at the top. The GPS receiver is located there and its
reception could be impaired.