60309 gps/tmc receiver bt-453te version a user manual 1588.
-- 1588 -- user manual (60309) gps/tmc receiver bt-453te 1. Introduction the gps/tmc receiver bt-453te is a gps receiver with bluetooth interface and internal tmc fm receiver. It has an active installed antenna for a high sensitivity for reception of the gps signals. Based on the sirf3 chipset it su...
-3- important health- and security information if you use this product you should take precautions to avoid damages and legal consequences. Follow precisely all security- and handling advice and keep it carefully. Pay attention to all warning notices in the manual and on the device. To avoid injury,...
-4- avoid using the device right after high thermal fluctuation. Condensation in the device might occur if you expose the device to high thermal or humidity fluctuation. In order to avoid damages wait until the humidity is evaporated, before using it. Note: if you bring the device from a cold into a...
-5- 5. Exit the bluetooth-manager. 6. Launch the suitable software for mapping/navigation, and select the correct com port and set the baud rate to 38400. 1. Perform a softreset on your device if you have any errors or configurationproblems. It can be performed before or after interconnecting, in or...
-6- 5. After you chose the com port and the baud rate you can connect the tool with bt-453te and have the data displayed. Click here the button „start gps“. 6. The egnos correction cannot be activated. See note 1.3 7. Switch with tab from setup to gps info when the nmea protocol is displayed. 8. The...
-7- 4. Testing the bluetooth gps receiver 4.1 test tool for pda 1. Install the wm5.Exe and wm.03exe respectively according to operating system on your pda. For this an active connection between desktop pc and pda via active sync is required. The installation runs from the desktop pc to the pda. The ...
-8- 4.2 using the gps info program to test the gps receiver launch the copied gpsinfo program file, adjust the com port according to the bluetooth pairing and set the baud rate. Then click on start gps. Shortly after doing this the log should start running in the nmea data window. Make sure that no ...
-9- windscreen, just attach the fm antenna to the side window. Check the settings of your software, if the same com port for the data reception of tmc information is set, like the com port for gps. The receiver sends only on 38.400 baud. Another baud rate does not enable a reception of the data of b...
-10- bluetooth-specification compatibility bluetooth v1.1 compatible frequency response 10 m (typical) certificate ce 7a06111eb r&tte (1999/5/ec) 6a111004es 7. Safety notes when driving the navigation system must not be operated by the driver. Use your navigation system according to traffic regulati...
