Navitel MSR700 User Manual - page 14
14 |
USER MANUAL
EN
Installation
1. Stop the car engine.
2. Put the SD card into the DVR.
Note
:
use a high-speed SD card (Class6 above); capacity should be within 8-256 GB.
3. Secure the device on the windshield with the adhesive mount.
4. Connect the car charger to the cigarette lighter socket.
5. Connect the USB interface to the car charger with the charger extension cord.
Note
:
charger extension cord can be placed along the edge of the windscreen.
6. Adjust the camera position; make sure the lens is facing parallel to the ground.
7. Start the engine; check whether the device is installed correctly.
Note
:
if the device is installed correctly, the indicator will glow red; the device will start up and begin recording (indicated by flashing blue light).
Precautions
1. Use our special adapter; using a different adapter may cause irreparable harm to the device.
2. Do not use the device in humid or hot environment.
3. Keep the lens clean.
4. Do not disassemble the device without authorization.
5. Strictly abide by the relevant national laws. This product is not to be used for illegal purposes.