Naxa NAS-3059 Instruction Manual - page 6

Page 6 

Naxa Electronics

Using the AUX Input 

Connector

Connect devices without Bluetooth

®

 by using the AUX 

connection. The included 3.5mm AUX cable is required 

to make this connection.

1.  Press   to set the active speaker mode to AUX.

2.  Use the 3.5mm plug of the included AUX cable to 

connect the device’s headphone or line-out jack to 

the AUX connector of the speaker.

3.  Turn on the device and the speaker. Lower the vol-

ume on both.

4.  Set the device volume to 80% of its maximum and 

then start playback.

5.  Press and hold   to gradually increase the volume 

of the speaker to a comfortable level.

L

L

Use the connected AUX device to control 

all functions in AUX mode. The speaker can 

only be used to adjust the volume.