Naxa NAS-3070 Instruction Manual - page 4
Page 4
Naxa Electronics
Connecting Power
Your speaker has an integrated rechargeable battery.
Upon initial use, the battery should be charged fully to
ensure optimal performance and battery life.
Use the included USB cable to connect the speaker to a
USB power source to charge the battery.
• Connect the small end of the cable to the USB
charge port [6] of the unit.
• Connect the large end of the cable to a high-power
USB port of a computer. The computer should be
powered on.
⚠
⚠
The battery used in this device may pres-
ent a fire or chemical burn if mistreated.
Do not disassemble, incinerate, or heat the
battery. Do not leave the battery in a place
subject to direct sunlight, or in a car with its
windows closed.
Do not connect the unit to a power source
other than that which is indicated here or on
the label as this may result in the risk of fire
or electric shock.
The power indicator will light a steady red when the
battery is charging. When charging is complete, the
power indicator will darken.
The power indicator will flash red when the battery
level is low.
⚠
L
It takes approximately 2 hours to charge
the unit fully when connected to a stan-
dard USB port.
The battery will charge even if the speaker is
switched off.