Naxa NAS-3078 Instruction Manual - page 6
Page 6
Naxa Electronics
Using the Speaker
Pairing a Device with Bluetooth
®
A device must be paired with the speaker before using
them together for the first time.
Make sure Bluetooth is enabled on your device before
attempting to pair it.
When you turn on the speaker, it will automatically
search for a paired device. If it finds a paired device,
it will connect to it automatically, and you’re ready to
play music from that device.
If it does not detect a paired device, it will switch to
Pairing mode (the Status indicator [2] will flash blue
and the speaker will emit a tone). When the speaker is
in Pairing Mode, it will announce itself to nearby Blue-
tooth devices and accept pairing requests from them.
1. The speaker will announce itself as “NAXA NAS-
3078.” Use your device to search for nearby Blue-
tooth devices. (This function is usually in the
Bluetooth settings menu; refer to your device’s in-
struction manual to learn more.)
2. Select “NAXA NAS-3078” from the list of found de-
vices. If your device asks for a passcode, use “0000”
to complete the pairing process.
3. The speaker will emit an ascending 6-note tone
when the speaker is paired and connected to a de-
vice.
When the speaker is paired and connected to a device,
the speaker will beep and the Status indicator [2] will
light a steady blue.
L
L
If the pairing process fails, turn the speaker
off and back on again, and then repeat
steps 1-3.
Make sure that the volume of your device is
set to its maximum level; use the speaker
to adjust the volume to a comfortable
level.
The speaker cannot be paired with more
than one device at a time.