DL manuals
Naxa
Car Receiver
NCA-681
Instruction Manual

Naxa NCA-681 Instruction Manual

Page of 8

Download

Print this page

Bookmark us

INSTRUCTION MANUAL

MODEL: NCA-681

IMPORTANT INFORMATION REQUIRED BY THE FCC

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1)this device may not cause harmful interference; and (2) this device must accept

any interference received, including interference that may cause undesirable operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation .

This equipment generates.uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio elevation

reception, which can be determined by turning the equipment off and on. The user is encouraged

to try to correct the interference by one or more of the following measures:

* Reorient or relocate the receiving antenna.

* Increase the separation between the equipment and receiver.

* Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

* Consult the dealer or an experienced radio/TV technician for help.

Fold Down Full Detachable PLL Electronic Tuning

Stereo AM/FM Radio, MP3/CD Player & Remote Control

1 2 3 4 5 6 7 Next › »

Summary of NCA-681

Page 1
Instruction manual model: nca-681 important information required by the fcc this device complies with part 15 of the fcc rules. Operation is subject to the following two conditions: (1)this device may not cause harmful interference; and (2) this device must accept any interference received, includin...
Page 2
Dear customer: thank you for purchasing this car audio product. Selecting fine audio equipment such as the unit you have just purchased is only the start of your musical enjoyment. Now it is time to consider how you can maximize the fun and excitement your equipment offers. We hope you get the most ...
Page 3
Page 2 1. Open button press the open button to fold down the front control panel. Then a cd can be inserted into the cd slot or ejected by pressing the ej button. After flipping down the front panel, push it rightwards firstly, then draw the left of the panel outwards to remove it from the unit chas...
Page 4
Page 3 page 12 b) when pressed longer 2 seconds, it is activated as cyclical mode of following functions for user’s selection. ->beep (on/off) -> user set(flat/classic/rock/pop) ->vol(last/defa) ->clk(on/off)->clk(12/24)mode. After selecting the desired mode, rotate the vol knob to select one setup ...
Page 5
Page 4 page 11 9. Mute button this button serves to switch the muted state on/off. Press the mu button to suppress the loudspeaker temporarily, and press again to resume listening. The muted state will be also released when the mode, sel button is pressed and vol knob on the front panel is used. 10....
Page 6
, int, rpt, rdm buttons a) during radio mode: when pressed short, these buttons select a preset station directly. If the six buttons are pressed for more than 2 seconds, the station currently being listened to is memorized into the selected pres...
Page 7
Page 9 page 6 note: 1.Make sure use a speaker with 4 ohm load impedance. 2.Do not make the auto antenna wire and ground touch each other. Wiring diagram + + + + yellow antenna plug constant b+ black(gnd) ignition switch red (b+) front rear right front white white/black green/black violet/black gray/...
Page 8
Page 8 page 7 1. Power on/off. 2. Mute button 3. 4. Level/menu up button 5. Sel/menu loudness button button 6. Level/menu down button 7. Mo/st button 8. A.P button 9. Band button 10. Mode button 11.Tune/seek up and track skip up/ff button 12.Tune/seek down and track skip down/rew button 13.Scan butt...