Naxa NHS-2003 Instruction Manual - page 7
POWER SOURCE
Insert the AC plug into a conveniently located AC outlet having AC 120V~60Hz.
WARNING: This unit has a long AC cord that can easily be tripped on or pulled
on, causing injury. Please make sure it is arranged so it will not drape over a
tabletop, etc. where it can be pulled on by children or tripped over accidentally.
GENERAL OPERATION
PLAY RADIO
6
3. Press the
VOL(Volume)+/- Buttons to adjust volume level.
4. Press the
EQ button to set EQ (equalizers) mode as desired.
5 Press the Button on the remote control to turn off the sound. Press it again
to turn it back.
6. If the unit is not used for a long period of time, pull out the plug to turn off the
unit completely.
Note:
- If no USB device or CARD was inserted, USB or CARD mode cannot be
selected by SOURCE button.
- In Bluetooth mode, the indicator will flash a few seconds then show a solid
blue light after pressing Play/Pause key for Pause.
Press the button to turn on the unit.
1. Press
SOURCE button repeatedly until the Indicator color turns to Indigo.
To enhance radio reception ability:
FM: Fully unwind the antenna wire. Extend the antenna wire and place it in the
position that sounds best.
Note:
•
All the received stations by using or can not be stored into the memory.
You can also manually search for a station by pressing and hold or button
to search for the available stations.The unit will stop when a station is found.
Shortly the playback will begin.
•
2. Press button to turn on the unit. Press the
Button repeatedly until
SOURCE
Wait for a few seconds,
(AUX 2). the unit
the indicator turns Green (USB), Blue (SD card), Indigo (Radio), Light Green
(AUX IN 1) and Violet
will play the music
files automatically.
LISTENING TO AUXILIARY SOURCE
1. Connect your auxiliary source (e.g. TV, DVD, VCR player) to the AUX 1 jack
(RCA). Or connect your auxiliary source (e.g. iPod / iPad / MP3 player) to the
AUX 2 jack (3.5mm ).
2. Press button to turn on the unit.Press the
SOURCE Button repeatedly until
the color of Indicator turns to Light Green (AUX 1) or Violet (AUX 2).
3. Start playback from your auxiliary source.
4. Adjust the volume to desired level.
5. To stop playback, disconnect your auxiliary source from the AUX jack.
stations then stored into the memory automatically.
all available
2. Press the button or press and hold button and then the unit will start
to search
FM SCAN
3. After finished FM SCAN, press numeric buttons then wait for approx 3
seconds, you can select 1-20 preset stations. eg: pressing “1”, means preset
station 1. pressing “2” + “0” means preset station 20. Or press to cycle through
and listen to the preset stations.
1. Move the Power ON/OFF switch on the rear of the unit to ON position.