Naxa NHS-7008 Instruction Manual - page 12

Page 12 

Naxa Electronics

Getting Started

Turning the Unit On and Off 

To turn the unit on, press the   button [8]. The display 

screen [2] will light up.

To place the unit in Standby mode, press the   but-

ton on the remote until the display screen [2] shows the 

time. 

To turn the unit off completely, disconnect the unit 

from power.

Setting the Time

The time is shown on the display screen [2] when the 

unit is in Standby mode. To set the time:

1.  Press and hold the CLOCK/MO/ST button on re-

mote control. The hour digit will blink.

2.  Press the TUN- or TUN+ button [4, 5] to adjust the 

hour while it is blinking. Press CLOCK/MO/ST to 

save the hour; the minutes will blink.

3.  Press the TUN- or TUN+ button [4, 5]  to adjust the 

minutes while it is blinking. Press CLOCK/MO/ST to 

save the minutes. The time is now set.

Setting the Source Mode

Press MODE [8] to set the active source mode. This 

controls which connection is being used.

The display screen [2] will indicate which mode has 

been selected when MODE [8] is pressed.

Display Screen

Connection Mode

FM

FM radio

BT

Bluetooth

®

USB

USB [13]

CARD

SD/SDHC card reader [14]

OPTI

Optical audio input [12]

AUX1

3.5mm audio input [9]

AUX2

RCA stereo input [11]