1.
2 important notes introduction thank you for buying our product. Please read through these operating instructions, so you will know how to operate your equipment properly. After you finished reading the instructions manual, put it away in a safe place for future reference. Warning to prevent fire or...
3 features and controls 1. Handle 2. Cd compartment 3. Cd door open/close 4. Standby on/off button 5. Power indicator 6. Fm stereo indicator 7. Display 8. Volume control 9. Tuning control 10. Bass boost button 11. Cd play/pause/usb button 12. Cd stop button 13. Cd skip/search backward button 14. Cd ...
4 am band select am mode by band selector switch. Turn the tuning control to select the desired station. For am reception, the set is controlled by a built-in ferrite aerial which is directional. Therefore, the set should be positioned for the best signal strength. Loading the batteries into the rem...
5 tape recording a. Install a cassette tape. B. Set the function switch to “radio” position. After selecting the desired band and tune the tuning knob to desired broadcast station. Then push down record button and play button simultaneously. C. After recording the desired broadcast, depress the stop...
6 using the cd/mp3 loading a disc 1. Set the function switch to cd/mp3/usb/aux position. 2. Open the cd door. 3. Place an audio cd into the tray with the label side facing up. 4. Close the cd door. The total number of tracks will appear on the display after several seconds. 5. To remove the cd, pres...
7 to erase the memory (program) to clear the program, you have two options: 1. Press the stop button when the disc is stopped, or 2. Open the cd compartment lid, program will be erased. Repeat to repeat a single track 1. Press the prog./p-mode button once in play mode, “ repeat ” will flash on the d...
8 aux in operation this unit has provided special aux in jack, through this jack other audio sources can be connected to this unit and be amplified. 1. Set the function switch to cd/mp3/usb/aux position. 2. Connect the audio cable into the aux in jack and the other end connect to the audio out jack ...
