Naxa NSM-439 Instruction Manual - page 13
12
NSM-439
A. Seat the mounting bracket on
the stand while making sure
that the screw hole positions
are aligned with each other
(refer to the drawing below).
B. Use two of the included screws
to fix the bracket to the stand.
Mount the unit onto the bracket
by aligning the 4 slots on the
bottom of the unit with the 4
hooks of the bracket.
A. Mark 4 points on the wall and then
drill holes at each point. (Use the
mounting bracket and a level as a
guide when marking the points.)
B. Fix the bracket to the wall with 4
screws.
C. Mount the unit onto the bracket by
aligning the 4 slots on the bottom of
the unit with the 4 hooks of the
bracket.
Note: If mounting onto drywall, you will need
to install drywall anchors before
screwing the bracket into the wall.