Naxa NTD-1351 Instruction Manual - page 10
Turning the TV On and Off
2. Press
POWER
button on the remote control or
button on the LCD TV.
3. Normal picture will be displayed on the screen after
6 seconds. If no signal input, "No Signal" will be
displayed on the screen.
4. If temporary POWER off is required, press
POWER
button on the remote control or
button on the LCD TV.
5. If you want to completely switch off the power for this unit, unplug the power cord plug
for this unit.
6. After switching off the unit, you should turn on the TV again at least 5 seconds later.
Status indication lamp
Green: In power on mode.
Red: In standby mode.
Auto power
-
off
If there is no signal input in any Mode, the TV will automatically accesses the standby
state in about 15 minutes.
Memory before turning TV off
The settings of picture and the preset channels will be memorized at turning off the unit.
When being started up again, the unit will work according to the mode set before being
turned off.
1
How to turn the TV on or off
Basic Operation
Menu operation
1
Basic Operation
V
olume Adjustment and Mute Setup
Volume adjustment
Press
VOL +/-
key on the remote control or on the TV to display "Volume" menu,
adjust the volume of TV between 0 to 100 by using
VOL +/-
key:
(
To increase the volume, press
VOL
+ key;
(
To decrease the volume, press
VOL -
key;
Mute
Press
MUTE
key on the remote control to display mute icon on the
left bottom of the screen, and the
volume of TV will be turned off, press
MUTE
key again to turn on the volume.
Mute can be canceled by using
one of the methods below:
(
Mute will be canceled if you press
MUTE
button again.
(
Mute will be canceled if you press
VOL
+ key.
2
17
18