1 version 3.1.07 system reference manual system reference manual power pro power pro.
2 powerpro p515 program track test track track 14 to 18 volts ac, 5 amp power supply optional extra cabs utp nce procab basic set up of 5 amp power pro system be careful an nce p515 power supply (15vac - 5amp) is the preferred transformer for your system. If you are using a different transformer be ...
3 quick start contents of the 5 amp power pro system: power pro system box with 4 pin and 2 pin plugs pro cab seven foot coiled cable twelve inch flat cable utp cab bus panel power pro system reference manual we recommend that you follow the instructions below to connect your system to a small test ...
4 the following cab buttons must be pressed in the proper sequence to acquire control of the locomotive #3 (in the above example locomotive #3 is already selected): a. Press select loco button once. B. Press the “3” button once. Do not press 0 then 3. C. Press enter. Note: by convention, all locomot...
5 completing the quick start operating one locomotive is fun — for awhile. But operating two or three locomotives is a lot more fun for a much longer time. Advancing beyond this simple dcc testing requires decoder installation into more locomotives and perhaps a few straight pieces added to your cir...
6 press 1 to set up the address. Active adr:short active adr:short active adr:short active adr:short active adr:short setup adr 1=yes setup adr 1=yes setup adr 1=yes setup adr 1=yes setup adr 1=yes by convention all dcc locomotive decoders are set to short address #3 at the factory. If your decoder ...
7 tip: rick lake of st. Louis passes along this simple but quite innovative suggestion that his wife, venita came up with. When wiring a railroad, use an old or not too special box car and paint one side red and the other side blue. You could also place a tag with a + sign on one side and a tag with...
8 advanced layout wiring nce procab nce procab power pro eb3 ph pro p515 rb02 utp utp utp procab r cab04e cab04p procab dpdt switch program/ mainline track nce mine processor.
9 menu navigation chart - pt.1 press prog/esc key to cycle through menu listings, then press enter to cycle through listing choices. 9 bin cv factory reprogram? 1 program on main prog loco: 1 address long or short enter address run loco 2 cv enter cv # enter value 3 cfg (cv29) direction bit speed st...
10 3 register enter register # enter value 4 paged programming 5 direct programming 7 recovery program factory reprogram? 6 nce effects output # choose effect direction of operation bulb or led 2 assign loco to cab loco # cab # 3 set system clock start/stop 12/24 hour hours minutes ratio 4 use progr...
11 nce corporation 82 east main street webster, ny 14580 (585) 265-0230 ncedcc.Com 05240300 05240300 05240300 05240300 05240300 05240300
