NCE SB3A Upgrade Manual
NCE SB5
Smart Booster v 1.65B
The SB5 Smart Booster adds expanded and updated features to a Power Cab
DCC system. The first and most noticeable feature is additional power (5 Amps)
to run trains and accessories.
Your PowerCab used with the SB5 can now be unplugged and used in true
walk around fashion. It no longer needs to remain connected for the system to
work.
Up to 6 cabs can be used with the SB5 (Cab address range 2 through 7).
Equipped Cabs have up to six recalls each when used with the SB5.
Additional 5 Amp boosters (DB5) may be added to the SB5 for even more
power handling on larger layouts.
This manual covers only the addition and installation of the SB5 to a Power Cab
system. For operation consult your Power Cab manual.
The SB5 does NOT have a programming track output. The basic Power Cab
provides this capability.
© 2013 NCE Corporation
Page 1
INSTALLING THE NCE
SB3A/
SB5 UPGRADE CHIP
1.
Unplug the
SB3A/
SB5.
2.
Remove the 2 screws that hold the top to the bottom of
the case.
3.
Carefully work the top of the case up and off. Set aside.
4.
Locate the
Microprocessor chip
along the right hand
side of the case. It is
the largest chip
inside the
SB3A/
SB5.
5.
Use a small Flat screw driver or hobby knife to
separate the
Microprocessor chip from
the socket. Make sure you
pry BETWEEN the socket
and the chip. Work end to
end lifting a little on one end, then a little on the other end.
Pry the Microprocessor chip straight up from the socket. You will no longer need
this chip but hang on to it for the time being.
6. The new Microprocessor chip may come to you with its legs
slightly splayed outward. You will need to bend these legs so
that they are straight down from the sides of the chip. Place the
chip on a flat, hard surface as shown in the diagram and bend
the body of the chip so that the legs are straight. Repeat with
the opposite side legs.
7. There is a small “U” shaped indent or dimple in one end of the chip.
This is the TOP of the chip. Place the chip on the socket with this “U”
shape toward the rear of the case.
8. Align the legs to the socket. When satisfied that ALL of the legs are in
line with a socket position, press the new chip down into the socket.
Work from end to end, press a little on one end, then a little on the other
end. Keep doing this until the Microprocessor chip is FULLY seated in
the socket.
9. Examine the installation to ensure ALL 28 of the legs have
engaged the socket correctly.
10. Replace the top of the case and the 2 screws that hold the top to
the bottom. DO NOT OVERTIGHTEN THE SCREWS. You could
inadvertently break the screw boss inside the case.
11. Plug the
SB3A/
SB5 back into your railroad and enjoy the greatest train control in model
railroading!
Make sure none of the legs
are bent under or outside
the socket.
Pry here
Do Not pry here
Dimple
“U” shaped
indent
Correct
Splayed
Microprocessor
U Shaped Indent