1. DL manuals
  2. NCE
  3. Media Converter
  4. SWITCH-8
  5. Manual

NCE SWITCH-8 Manual

Summary of SWITCH-8

  • Page 1

    Switch-8 accessory decoder for stall motor machines only not for use with twin coil switch machines decoder revision a $59.95 eas y programming! ‚ control for 8 tortoise tm switch machines ‚ switch -8 remembers the position of switch during power outages ‚ switch - 8 supports the full range of dcc a...

  • Page 2

    Notes: this decoder is designed to control tortoise, switchmaster or other low current "stall motor" switch machines. The outputs are rated for 50ma maximum. Most tortoise machines draw 1 0 to 20 ma with normal track voltage (about 13-15 volts). There are four mounting holes at the corners of the sw...

  • Page 3

    Factory default values for decoder output s 1&2 factory programmed to accessory address 1 output s 3&4 factory programmed to accessory address 2 output s 5&6 factory programmed to accessory address 3 output s 7&8 factory programmed to accessory address 4 output s 9&10 factory programmed to accessory...

  • Page 4

    Reversing the polarity of an output : use ops mode programming for accessories (“prog” followed by “7” on nce systems) to program cv33 to a value of 1. If your dcc system does not support ops mode programming for accessories you can just swap the two wires to the switch machine. Note:the nmra comman...