NEAR OPS1 Installation And Use Manual

Summary of OPS1

  • Page 1

    © 2003 bogen communications, inc. All rights reserved. Specifications subject to change without notice. 54-2090-01b 0406 orbit pendant speaker ops1 installation and use manual 54-2090-01b.Qxp 6/18/2004 10:32 am page 1.

  • Page 2: Product Description

    Product description thank you for choosing near ® orbit pendant loudspeakers. You have purchased one of the finest pendant loudspeakers available today, the near model ops1. Please familiarize yourself with this product by reading and reviewing the following descriptions and diagrams in this manual....

  • Page 3: Product Diagrams

    Product diagrams ops1 front drawing 1 .Tap selection switch 2. Coaxial driver assembly 3. Grille retention slot 4. Bass tuning vent (x2) 5. Perforated steel grille ops1 rear drawing 6. Snap-lock input connector 7. Suspension points (x3) 8. Safety cable suspension point package contents (1) orbit pen...

  • Page 4: Selecting Power Level

    Selecting power level select the power level using the front-mounted selector switch. The speaker grille must be removed prior to selecting the power level. See speaker grille installation & removal section for proper grille removal procedures. Selecting power level the front-mounted selector switch...

  • Page 5: Speaker Wiring

    3 speaker wiring wiring is terminated at a snap-lock input connector. There are two positive and two negative terminals to accommodate daisy- chaining of speakers in a system. All wiring should be done prior to installation and then plugged into the rear of the ops1. Daisy-chaining the ops1’s snap-l...

  • Page 6: Speaker Installation

    4 speaker installation suspension cable assembly 1 . Screw nuts onto the three (3) eyebolts all the way to the flange. 2. Screw in eyebolts with captured cable sections into the three (3) suspension points. Do not overtighten. 3. Snap the loops of the three (3) free ends of the cable sections into t...

  • Page 7: Specifications

    Specifications 5 specifications ops1 frequency response (-10 db)* 60 hz to 19 khz lf driver 6- 1 / 2 " mdt metal-alloy cone (mls voice coil centering system) hf driver 20 mm ( 3 / 4 ") polycarbonate dome sensitivity (1w/1m) 89.5 dbspl (average 100 hz - 10 khz) dispersion 1 20° impedance ratings low ...

  • Page 8: Limited Warranty

    50 spring street, ramsey, nj 07446, u.S.A. Tel. 201-934-8500, fax: 201-934-9832, www.Bogen.Com limited warranty the orbit pendant speaker, model ops1, is warranted to be free from defects in mate- rial or workmanship for five (5) years from the date of sale to the original purchaser. Any part of the...